Battery Cover Installation Guide

Back to All Guides
Floor & Wall Mount 20–30 Mins

Follow our step-by-step video tutorial and written guide below to assemble and securely mount your Simply Covers Battery or Inverter Cover.

Parts Checklist

  • 1x Front Panel
  • 1x Top Panel (Roof)
  • 2x L-Frames
  • 1x Bag of Fixings
  • Floor-Mount 2x Leg Inserts & 2x Adjustable Feet

Tools Needed

  • Hammer or Rubber Mallet
  • Pin Punch / Small Driver (for hinge pins)
  • Cordless Drill & Screwdriver
  • Spirit Level & Pencil

Phase 1: Assembly

5 Steps
1

Unboxing and Prep

Choose a flat, solid surface and lay out all components. Use the flattened cardboard packaging underneath to protect the cover panels and frame from scratches during assembly.

2

Attach Legs

Floor-Mount Only

Attach the leg inserts to the bottom of the L-Frames by lining up the coloured dots.

3

Assemble Main Frame

Attach the L-Frames to the roof panel. Using a hammer or rubber mallet, gently tap the end of the L-support until the square aluminium section slides fully down and sits flush with the frame.

4

Attach Front Panel Door

Tap the hinge pins out of their temporary location on the roof panel. Lay the large front panel onto the frame and align the hinges. Insert the hinge pins back into the aligned hinges and tap until fully inserted.

5

Add Adjustable Feet

Floor-Mount Only

Insert the adjustable feet into the bottom of the cover's legs.

Phase 2: Installation

4 Steps
1

Position and Level

Position your assembled cover against the wall over your battery or inverter. Floor-Mount Adjust the threaded feet if necessary to keep the cover perfectly level.

2

Mark Pilot Holes

Mark the pilot holes for the mounting arms against the wall.

Pro Tip: Mark and affix the top two fixing brackets first, then align the vertical frame to the front and mark the bottom two brackets.
3

Drill and Mount to Wall

Move the cover aside, drill the pilot holes, and insert the wall plugs. Align the cover back over the plugs and mount it securely to the wall using the provided screws.

4

Finishing Touches

Peel off all protective plastic film from both the inside and outside panels of the cover. Clip the front cover door closed securely using the interlocking 3M Dual Lock fasteners.

Need Installation or Fitment Support?

Have custom clearance questions or site-specific mounting conditions? Call us on 07 3544 6503 or email info@simplycovers.com.au.